|
|
 | | Re: Palm Tree Junior
|
| That's a 1x2 plate with HANDLE, not side-clip ;-) Everyone else was talking about the new 1x2 brick with side clip (horizontal clip, holds things vertically). (...) -- | Tom Stangl, Technical Support Netscape Communications Corp | Please do not (...) (25 years ago, 9-Mar-00, to lugnet.dear-lego)
| | | | | Re: Elements I'd like to see...
|
| (...) James, we must be reading from the same wish list. I like your answers! I would add to the sloped bricks, inside (concave) corner bricks in extreme and low slope sizes (along with the needed peaks and peak connectors). I would also like to (...) (25 years ago, 9-Mar-00, to lugnet.dear-lego)
| | | | | Re: No LEGOFest...
|
| Richard Schamus wrote: <snip> (...) actually, with that set you throw them out the 1x4x3 transparent blue thin wall. -- dave (25 years ago, 9-Mar-00, to lugnet.trains.org, lugnet.dear-lego, lugnet.general)
| | | | | Re: Elements I'd like to see...
|
| (...) Since the topic has come up again...I'd like to see: Inverse corners, roof peak ends, roof peak joiners, and roof peak corners for the low-sloped bricks. Ditto for the steep sloped corners. Pieces for changing roof pitch - mostly corners and (...) (25 years ago, 9-Mar-00, to lugnet.dear-lego)
| | | | | Re: Palm Tree Junior
|
| (...) I find this piece good, actually. It allows me to center things in walls that are even in length (2 studs, 4 studs, etc), which can't be done with a 1x1 plate w/clip. Having the various clips on bricks also means that the back side of the wall (...) (25 years ago, 9-Mar-00, to lugnet.dear-lego)
|
|
