 | | Re: Radiosity example (F1 Ferrari) once again
|
|
(...) Yours look good as well but the edges seem a little "jaggy". Are you using anti-aliasing? The good news is that Nico's setting are a snap to implement. -Orion (20 years ago, 25-Sep-04, to lugnet.cad.ray, FTX)
|
| |
| | Re: Radiosity example (F1 Ferrari) once again
|
|
Mine look purhaps abit 'edgy' since I don't like to use the lgeo library. Too many parts are not available and if I combine them with the standard parts it don't look all that good. (2 URLs) first attempt>> This is my first attempt with Nico's (...) (20 years ago, 26-Sep-04, to lugnet.cad.ray, FTX)
|
| |
| | Re: Radiosity example (F1 Ferrari) once again
|
|
Am Sonntag, den 26.09.2004, 10:46 +0000 schrieb Jan Folkersma: (...) Well, I don't have a problem with "mixed" models with LGEO elements and standard parts. The big advantage of LGEO is, that the edges are rounded a bit, so you don't need the gap (...) (20 years ago, 30-Sep-04, to lugnet.cad.ray)
|
| |
| | Re: Radiosity example (F1 Ferrari) once again
|
|
"Nico Kaiser" <nico@siriux.net> wrote in message (...) Are you 100% sure about this? Usually the stair effect is caused by a lack of anti aliasing. Rendering the image at a huge resolution then doing a resize with proper resampling is more or less (...) (20 years ago, 30-Sep-04, to lugnet.cad.ray)
|
| |
| | Re: Radiosity example (F1 Ferrari) once again
|
|
(...) After looking closely at the forklift image, I think the stair-step effect is happening due to POV-Ray's adaptive antialiasing algorithm. It's much quicker to render the image at the desired resolution with adaptive antialiasing enabled in POV (...) (20 years ago, 30-Sep-04, to lugnet.cad.ray)
|
| |
| | Re: Radiosity example (F1 Ferrari) once again
|
|
"Travis Cobbs" <tcobbs@REMOVE.halibut.com> wrote in message news:I4vn98.21q3@lugnet.com... (...) there. (...) sure (...) made (...) spectacular (...) I have used the anti-aliasing quite extensively, although just by using the defaults I've never (...) (20 years ago, 4-Oct-04, to lugnet.cad.ray)
|
