 | | Re: Problem finding standard parts in MLCAD
|
|
(...) As I understand it, 1 x 1 brick is "3005.dat", but due to a bad alphanumeric order, ALL of the lettered and numbered 1 x 1 bricks (3005-*.dat) come before "3005.dat". As for the 1 x 2 brick, the normal (unpainted) one is "3004.dat". The one (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Re: Problem finding standard parts in MLCAD
|
|
(...) Hit "Regenerate List"? Elaborate. Although I'm sure that it's a command I missed, but please tell me more. (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Re: Newbie question about MLCad
|
|
(...) I want to thank you and Simon for helping me. I've finished my first DAT and you can check it out if you'd like (be careful, it's space!): (URL) again! -- dataAndrew (URL) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Re: Newbie question about MLCad
|
|
(...) World Origin or Custom, which means that the piece is rotating around either (0,0,0) or some other point, probably outside the piece you're rotating. Have you selected just one piece or more than one? If more than one, the rotation point will (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Re: Newbie question about MLCad
|
|
(...) You are rotating it around a centre point which is represented by a cross that you will find somewhere on the model, you can grab this and drag it to the point around which you would like to rotate. Once you have performed the rotation right (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Re: Problem finding standard parts in MLCAD
|
|
OK, thanks all! Jaco (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Newbie question about MLCad
|
|
Everytime I need to rotate a piece, it moves off the model. Then when I try to place it back where it belongs, it's off center (it's not completely on both of the studs). It seems hard to explain without a picture so let me know if you need one. -- (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Re: Problem finding standard parts in MLCAD
|
|
(...) I know the version you mean. One important note about that: It was <NOT> LDAO that was the problem! Steve Bliss would never have let something like that through! The problem was the self-extracting installation program he packaged it in. He (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Re: Problem finding standard parts in MLCAD
|
|
(...) Yes, there is that. I am using an older version. I thought Steve had put back a stable (older) version on the download site but I may be wrong. I do have the install image for that older version around somewhere if folks needed it. It hasn't (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Re: Problem finding standard parts in MLCAD
|
|
Is LDAO stable? The last time I installed it, I had to reinstall my machine... :-( (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
