 | | Re: Problem finding standard parts in MLCAD
|
|
(...) If regenerating doesn't do it for you, because you just can't remember that, for example, garage door slats are filed under Roller and not garage and not door and not panel and not slat.... (yes, I was trying to find these today, no comment on (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Re: Problem finding standard parts in MLCAD
|
|
(...) That seems to have done it! Thanks! Jake --- Jake McKee AFOL LUGNET Member #211 (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Re: Problem finding standard parts in MLCAD
|
|
did you hit regenerate list? mine was same way heh -- And they said 'Computers will never be in general use' "Jake McKee" <sink@countersinkdg.com> wrote in message news:GEHnoC.Ftz@lugnet.com... (...) brick, (...) I (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Problem finding standard parts in MLCAD
|
|
All, I am starting to actually _create_ MLCAD based models and I am having trouble locating some of the basic parts. 1x1 brick, 1x2 non-printed brick, 45 Slope 2x2 non-printed and 1x2 tile with one center stud are just a few I am having trouble (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Re: zoom function
|
|
(...) Bill, For every view except 3D, this is possible, but is not a one-step process. Step 1: Click on the piece you wish to center on in "Place Mode". (The square with the pencil and arrow indicates place mode.) Step 2: Change your model from (...) (23 years ago, 5-Jun-01, to lugnet.cad.mlcad)
|
