Subject:
|
Re: Printing problems in MLCAD
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Fri, 16 Feb 2001 16:42:46 GMT
|
Viewed:
|
2270 times
|
| |
|
|
I just found something about this - if the printer driver run's out of
memory - MLCad doesn't get notified or at least ignores the errors -
resulting in either blank pages (totaly blank) or also getting pages with
just some rubish on it ... I will take that into account for the next
version and make sure that errors in this case are not ignored.
Michael
--
================================
Ing Michael Lachmann
Individual software development
Tel.: +43 676 406 86 95
e-mail: michael.lachmann@lm-software.com
http: www.lm-software.com
"Jake McKee" <jacob.mckee@america.lego.com> wrote in message
news:G8uKrK.6C@lugnet.com...
> In lugnet.cad.mlcad, Larry Pieniazek writes:
> > Another thing is, did the images show up in print preview?
>
> Yep. The print preview shows it just fine. Everything is perfect right up
> until the actual print out process when the model won't print for • anything.
> The header/footer and parts list have no problem at all, but the
> parts/models will not print at all.
>
> jake
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: Printing problems in MLCAD
|
| (...) Yep. The print preview shows it just fine. Everything is perfect right up until the actual print out process when the model won't print for anything. The header/footer and parts list have no problem at all, but the parts/models will not print (...) (24 years ago, 16-Feb-01, to lugnet.cad.mlcad)
|
9 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
