Subject:
|
Re: Line width problem persists? (was Re: Printing problems in MLCAD)
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Thu, 13 Jun 2002 15:27:28 GMT
|
Viewed:
|
3328 times
|
| |
|
|
In lugnet.cad.mlcad, Eric Brok writes:
> In lugnet.cad.mlcad, Larry Pieniazek writes:
>
> SNIP
> >
> > Michael has an enhancement request from me to allow specification of line
> > thickness when rendering. I hope he does it. I'd bribe him to get it if I could.
>
>
> This was written over a year ago and now MLCAD offers a line width setting.
> However, I noticed that enlarging the line width *only* thickens the lines
> which were already discernable in the picture in the first place. It appears
> to have absolutely no effect on lines which were not discernably rendered at
> first.
>
> Questions:
> 1) Is this observation correct?
> 2) Did someone discover another way to make all lines discernable when
> exporting pictures from MLCad?
Just to close the loop here, I do not use MLCad image generation at all any
more. I have switched to LDLite completely for rendering. With the option to
clip the image to the size needed and the option to control line thickness,
it meets all my rendering needs. However my needs are different than many...
MLCad is aces in my book for design capture though.
|
|
Message is in Reply To:
9 Messages in This Thread:
  
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
