Subject:
|
Export Problems
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Sun, 26 Nov 2000 20:03:37 GMT
|
Viewed:
|
1738 times
|
| |
|
|
I'm fairly new to MLCad, and after I recently got ready to delve into the
depths of raytracing my designs, I found that the export command was a
little odd... I can't click the post processor configurations tab; it
doesn't act as if it's a tab at all. Neither of the Browse buttons on the
export config menu will work, and the OK button at the bottom won't work,
either.
My luck, it'll be some sickeningly simple problem I'm overlooking, but I
just thought I'd ask.
Thanks in advance,
Emily
|
|
Message has 3 Replies:
 | | Re: Export Problems
|
| (...) I don't use the export function so I can't comment. But if you want to raytrace, get POVray, install it, then get L3Lab (or L3P) and install it. What I do to trace is save my MPD with the design I want traced. Then I launch L3Lab, navigate to (...) (24 years ago, 26-Nov-00, to lugnet.cad.mlcad)
| | | Re: Export Problems
|
| (...) Only Michael can say for sure, but my belief is that this dialog is simply not fully functional yet. I would guess that all the fields and actions will become active in the next release. J (24 years ago, 27-Nov-00, to lugnet.cad.mlcad)
| | | Re: Export Problems
|
| This sounds something is wrong - the dialog wan't allow to continue until all the data are correct: 1) Make sure export path contains a valid directory name (e.g. C:\TEMP) 2) If you are using the processing log-file make sure the entry contains a (...) (24 years ago, 27-Nov-00, to lugnet.cad.mlcad)
|
7 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
