To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.mlcadOpen lugnet.cad.mlcad in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / MLCad / 303 (-5)
  Re: Suggestion?
 
(...) Could you start using sub-models. I've found it is a lot easier to break down models into sub-models. I can then work in an uncluttered view of just the area I'm working on. I've been doing mostly mechs, so it is real easy to break things (...) (24 years ago, 15-Aug-00, to lugnet.cad.mlcad)
 
  Re: MLCAD rotation (future request)
 
Ok, I will think on this too. Just a summary: There are four options for a single part rotation: 1 - Rotate via origin of the part 2 - Rotate via center of part 3 - rotate via world origin(0/0/0) and 4 - rotate over a user set rotation point. For (...) (24 years ago, 15-Aug-00, to lugnet.cad.mlcad)
 
  Re: Suggestion?
 
The sounds like a good idea. However you should check your settings, and see if the Position for new part is not centered, and the draw to selection only option is disabled .... this slows down very much. Thanks, Michael Adam Howard (...) (24 years ago, 15-Aug-00, to lugnet.cad.mlcad)
 
  Suggestion?
 
Hi Mike! I've been working on a large model and have run into the slowwwiiiinnnnggg-dowwn wall. Whenever I add a new piece or rotate a selected one it seems to take forever. I'm not sure, but I believe it is because MLCAD re-renders the whole model (...) (24 years ago, 15-Aug-00, to lugnet.cad.mlcad)
 
  Re: MLCAD rotation (future request)
 
(...) Um, me too. :-, Cheers, - jsproat (24 years ago, 14-Aug-00, to lugnet.cad.mlcad)


Next Page:  5 more | 10 more | 20 more

Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR