|
| | Parts selector on the left
|
| Hi all, Why are the parts on the left suddenly shown from top? How do I put the view to 3D again? I cannot seem to find it in the settings. Greetingz... Sjaacko (24 years ago, 22-Sep-00, to lugnet.cad.mlcad)
| | | | Re: "Step" mode for MLCad?
|
| (...) Thanks a lot, that was exactly the option I was looking for. Regards, Hakan (24 years ago, 21-Sep-00, to lugnet.cad.mlcad)
| | | | Re: "Step" mode for MLCad?
|
| Hakan, look under "Settings", "Change", the "Rendering" tab, in the Edit-Mode Options box, click "Draw to selected part only". I hope this is what you were looking for. Dennis (...) (24 years ago, 20-Sep-00, to lugnet.cad.mlcad)
| | | | "Step" mode for MLCad?
|
| Hi, In my previous installation of MLCad, I could step through the parts of a model, and MLCad would only draw the pieces up to the part I stepped to. After a re-install, I can't find an option to enable this behaviour anymore, I always see the (...) (24 years ago, 20-Sep-00, to lugnet.cad.mlcad)
| | | | Re: Pictures of my MLCad MOCs
|
| (...) I have POV-Ray and L3P but I'm still a bit confused about it. I have used L3P with a bit of success but I couldn't really figure out the coordinate system (I really didn't try that much though) and I'm not real fond of DOS commands. I was (...) (24 years ago, 18-Sep-00, to lugnet.publish, lugnet.town, lugnet.cad.mlcad)
| |