Subject:
|
Re: "Step" mode for MLCad?
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Wed, 20 Sep 2000 16:50:07 GMT
|
Viewed:
|
1763 times
|
| |
|
|
Hakan, look under "Settings", "Change", the "Rendering" tab, in the Edit-Mode
Options box, click "Draw to selected part only".
I hope this is what you were looking for. Dennis
In lugnet.cad.mlcad, Hakan Tandogan writes:
>
> Hi,
>
> In my previous installation of MLCad, I could step through
> the parts of a model, and MLCad would only draw the pieces up to
> the part I stepped to. After a re-install, I can't find an option
> to enable this behaviour anymore, I always see the whole model.
> Does this ring a bell with anyone?
>
> Regards,
> Hakan
|
|
Message has 2 Replies:
 | | Re: "Step" mode for MLCad?
|
| (...) Having this particular setting shortcutted (via a button on some toolbar, or via a cntl key sequence) would be very handy indeed. I find of the settings, this is the thing i turn on and off the most. I am OK with having to do a cntl-r to get (...) (24 years ago, 27-Sep-00, to lugnet.cad.mlcad)
|
Message is in Reply To:
| | "Step" mode for MLCad?
|
| Hi, In my previous installation of MLCad, I could step through the parts of a model, and MLCad would only draw the pieces up to the part I stepped to. After a re-install, I can't find an option to enable this behaviour anymore, I always see the (...) (24 years ago, 20-Sep-00, to lugnet.cad.mlcad)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
