Subject:
|
Re: what are the rules about hoses etc?
|
Newsgroups:
|
lugnet.cad.dev.org.ldraw
|
Date:
|
Thu, 29 Jul 1999 07:26:19 GMT
|
Viewed:
|
871 times
|
| |
|
|
> Hoses go in the model. End of discussion (unless a serious user comes up
> with a really good and logical reason otherwise).
what i meant to say is that the really large technic type flexable hoses cant go
into a model yet because they have not been made
|
|
Message has 1 Reply:
 | | Re: what are the rules about hoses etc?
|
| (...) You can create a reasonable rendition of a Technic hose using John Van's Hose spreadsheet and replacing the 754.dats with 4-4cyli.dats of the correct length and diameter. --Bram Bram Lambrecht / o o \ BramL@juno.com (...) (25 years ago, 29-Jul-99, to lugnet.cad.dev.org.ldraw)
|
Message is in Reply To:
| | Re: what are the rules about hoses etc?
|
| (...) Hoses go in the model. End of discussion (unless a serious user comes up with a really good and logical reason otherwise). (...) When it becomes possible, they are required too. (...) Yes and no. Some parts, depending on where they are in the (...) (25 years ago, 28-Jul-99, to lugnet.cad.dev.org.ldraw)
|
10 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
