 | | Re: Variants of 4.5v train motors —Chris Dee
|
| | | (...) Yes, including case is good. As Niels indicated, the 4 x 12 x 3 1/3 versions are openable with a screwdriver, allowing the actual motors to be replaced, so I think the term "Shortcut" is correct. The 4 x 12 x 4 version is glued, so I'll change (...) (20 years ago, 29-Jun-04, to lugnet.cad.dev)
|
| | | |
| | | | | Re: Variants of 4.5v train motors —Niels Karsdorp
|
| | | | (...) The actual motors (both 12V and 4.5V) were sold seperately as replacement packs, so users can screw open the case and replace the motor (either replacing a broken motor or replace a 4.5V motor with a 12V motor or vice versa). (URL) 12V (peeron (...) (20 years ago, 29-Jun-04, to lugnet.cad.dev, FTX)
|
| | | | |
| | | | | | Re: Variants of 4.5v train motors —Clark Stephens
|
| | | | (...) The cases were also sold separately: (URL) Set 1215 which was only the lower half of a Type II housing. It allowed a user to change a Type I motor (an earlier version without the hole) into the updated Type II (with the centre hole). HTH, (...) (20 years ago, 30-Jun-04, to lugnet.cad.dev)
|
| | | | |
| | | | | | Re: Variants of 4.5v train motors —Niels Karsdorp
|
| | | | (...) I just checked my motor cases. The Type I motor cases and Type 2 motor cases are NOT interchangable. To update a Type I motor to a Type II motor you need a Type II top case, a Type II bottom case and a Type II gearbox. (The gearbox is the (...) (20 years ago, 1-Jul-04, to lugnet.cad.dev)
|
| | | | |
| | | | | | Re: Variants of 4.5v / 12v train motors —Chris Dee
|
| | | | (...) Would you be able to take a critical look at the sizes of the connector studs and the holes in them. There is a suggestion that these differ between the versions designed to work with the old Blue 2-pin connectors ((URL) those which fit the (...) (20 years ago, 15-Jul-04, to lugnet.cad.dev, lugnet.trains)
|
| | | | |
| | | | | | Re: Variants of 4.5v / 12v train motors —Niels Karsdorp
|
| | | | (...) I checked my motors again, only one per type (I didn't want to dismantle all my locomotives that use the motors). Here are my measurement results: x570c01 (blue): Outer plug diameter: 5 mm Inner plug diameter: 2.1 mm Plug height: 2.1 mm (...) (20 years ago, 16-Jul-04, to lugnet.cad.dev)
|
| | | | |
