 | | Re: Building LDGLite for off-screen rendering only (Was: Parts Tracker Status)
|
|
(...) Or more likely, (since I just got the same result myself) is that I created the stubs and the new makefile for the stock 0.9.5 sources instead of the latest CVS sources since that's what I had lying around. Apparently I need a few more stubs (...) (21 years ago, 16-May-03, to lugnet.cad.dev)
|
| |
| | Re: Building LDGLite for off-screen rendering only (Was: Parts Tracker Status)
|
|
(...) I only glanced at the list of errors, but maybe this is the problem. If you already built ldglite then you have to start over from scratch with the new makefile. Unfortunately my makefile skills are not the best. There's no "make clean". So (...) (21 years ago, 16-May-03, to lugnet.cad.dev)
|
| |
| | Re: Building LDGLite for off-screen rendering only (Was: Parts Tracker Status)
|
|
(...) [...] (...) I should probably have written that it is on a Red Hat (mostly) 7.3 system with some kind of x86 processor. Play well, Jacob -- City X'ers mail van (building instructions): (URL) (21 years ago, 16-May-03, to lugnet.cad.dev)
|
| |
| | Building LDGLite for off-screen rendering only (Was: Parts Tracker Status)
|
|
[ XFUT lugnet.cad.dev ] (...) So far it works fine, but ... (...) This fails. Here's the end of the output from the build: ---...--- gcc -g -DUNIX -DUSE_OPENGL -DUSE_L3_PARSER -DUSE_BMP8 -DNEED_MIN_MAX -DUSE_PNG -DTILE_RENDER_OPTION -DOSMESA_OPTION (...) (21 years ago, 16-May-03, to lugnet.cad.dev.org.ldraw, lugnet.cad, lugnet.cad.dev)
|
| |
| | Re: Bendible parts Web Page
|
|
Yeah! I can't say right now that I would use it, but I have wanted the ability every now and then. And I am always for any software that will run on Macintosh, even if it is through a webpage (which is what you describe sounds like). James (...) (21 years ago, 12-May-03, to lugnet.cad.dev)
|
