 | | Re: Latest BFC Spec?
|
|
(...) Your fresh eyes are very welcome. We had long discussions where sections of the spec were changed/moved/rewritten over and over, and I think there are some unnecessary repetions and redundacies, so a new full rewrite would be quite beneficial. (...) (22 years ago, 14-Mar-03, to lugnet.cad.dev)
|
| |
| | Re: Latest BFC Spec?
|
|
(...) Yes. (...) Huh? Isn't NOCLIP/CLIP exactly for "un-commenting" a section (including subfile references) that hasn't been BFC checked? /Lars (22 years ago, 14-Mar-03, to lugnet.cad.dev)
|
| |
| | Re: Are Meta-commands case-sensitive?
|
|
(...) L3P and L3Lab treat the FILE case-sensitive. (...) I think the "file type" meta-commands are the only ones that have been defined to NOT be case-sensitive. And yes, the "syntax" is a mess :-) (...) I agree. (...) L3P and L3Lab: MPD - (...) (22 years ago, 14-Mar-03, to lugnet.cad.dev)
|
| |
| | Are Meta-commands case-sensitive?
|
|
I have a question about Meta-commands. Are meta-commands all supposed to be case-sensitive? As an example, is the 0 FILE MPD meta-command case-sensitive? I'm asking this because I have an MPD file that contains sub-files that themselves obviously (...) (22 years ago, 14-Mar-03, to lugnet.cad.dev)
|
| |
| | Re: Latest BFC Spec?
|
|
(...) This is really no different from the fact that the incoming certify state has to also be on. So a subfile won't be BFC'd unless all its parents are certified and it is certified as well. Also, presumably if you refer to a subfile in a section (...) (22 years ago, 13-Mar-03, to lugnet.cad.dev)
|
| |
| | Re: Latest BFC Spec?
|
|
(...) The spec should probably be updated to reflect this, I suppose. Please note that this comment and everything below is meant as constructive criticism. It's not meant as a complaint or a slight. I'd just like to see the spec improved. I'll even (...) (22 years ago, 13-Mar-03, to lugnet.cad.dev)
|
| |
| | Re: Latest BFC Spec?
|
|
(...) I'm currently doing this. Give me a couple of days. -Orion (22 years ago, 13-Mar-03, to lugnet.cad.dev)
|
| |
| | Re: Latest BFC Spec?
|
|
(...) What if file has NOCLIP, and subfile has CLIP (with or without accompanying NOCLIP)? Couldn't that become confusing? Should it automagically revert back to NOCLIP when the subfile is finished? ROSCO (22 years ago, 13-Mar-03, to lugnet.cad.dev)
|
| |
| | Re: Latest BFC Spec? [DAT]
|
|
(...) Sorry this wasn't clear. It does mean 'current file and all subfiles'. More accurately, it means 'turn off clipping until/unless it gets turned back on in this file, overriding any possibility of clipping in a subfile, until the end of this (...) (22 years ago, 13-Mar-03, to lugnet.cad.dev)
|
| |
| | Re: Latest BFC Spec?
|
|
(...) Please go ahead and do it. Make it so. Steve (22 years ago, 13-Mar-03, to lugnet.cad.dev)
|
