Subject:
|
Re: File Check utility (was: Case of part filenames?)
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Tue, 19 Feb 2002 20:45:17 GMT
|
Viewed:
|
1960 times
|
| |
|
|
In lugnet.cad.dev, Steve Bliss writes:
> In lugnet.cad.dev, Tony Hafner writes:
> > One related thing- is there any way that you could add the new checks to the
> > "File Check" utility as well? I had a number of parts that I had scanned
> > with that tool and they came up OK. Then the submission form refused the
> > parts. Waaah!
>
> Yep, I will do that. I think it should be pretty straightforward. Not
> quite as straightforward as it would be if they actually ran off the same
> source code, but close...
OK, it's done. It will probably be a problem going forward, until I can
clean up the code and combine it into one source.
Anyone ever played with lex and perl? That would probably be a better way
of doing this - the current code is pretty ugly.
Steve
|
|
Message is in Reply To:
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
