 | | Re: need help w/ name (minifig legs from set #4817)
|
|
(...) Peeron calls this one "Minifig Hips and Legs Assembly with Red and Brown on Legs and Belt Pattern" ("(URL) (Steve, Chris: I'll also need a pattern number (...) Steve, Chris, I was thinking of using these: 970p4b Minifig Hips - Leather (...) (23 years ago, 5-Feb-02, to lugnet.cad.dev)
|
| |
| | Re: BrickDraw3D development announcement
|
|
(...) Four cases that come to mind 1. as you say existing begin 2. command other than vert,color,index,nor...Co,evalPo, arrayEl,material,edg...allList(s) & Some '_EXT's if storable in begin end. Keep anything else after or before as needed. 3. Some (...) (23 years ago, 5-Feb-02, to lugnet.cad.dev)
|
| |
| | need help w/ name (minifig legs from set #4817)
|
|
I've gotten several of the minifig from set # 4817 ("(URL) I intend to encode the printed hips-and-legs for this minifig into LDraw. But, I need some help coming up with the name for the printing of this piece. In LDraw, I'll actually be encoding (...) (23 years ago, 5-Feb-02, to lugnet.cad.dev, lugnet.castle, lugnet.build.minifigs)
|
| |
| | Re: Name this Jack Stone part
|
|
(...) That pin in the middle, appears to add significantly to avoid unintentional disconnect. The tallness of the pillar with respect to the shortness of a typical stud would cause it to be much less stable without the pin. The Jack Stone parts (...) (23 years ago, 5-Feb-02, to lugnet.cad.dev)
|
| |
| | Re: Name this Jack Stone part
|
|
(...) Hmm.... Brick 10 x 10 with Corner Extensions Brick 10 x 10 with Corner Support Extensions Brick 12 x 12 without Sides Jack Stone BaseBrick 10 x 10 Whichever dimension (10x10 or 12x12) is used in the part, the *other* dimension should be (...) (23 years ago, 5-Feb-02, to lugnet.cad.dev)
|
