Subject:
|
Re: Name this Jack Stone part
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Tue, 5 Feb 2002 19:40:56 GMT
|
Viewed:
|
775 times
|
| |
|
|
In lugnet.cad.dev, Steve Bliss writes:
> In lugnet.cad.dev, Ray Sanders wrote:
> > And while we/you are thinking about this, the 2 x 2 x 8 column piece (p/n 30646)
> > also needs a name. It has a vertical groove on all four sides and has internal
> > structure on two of four sides.
>
> Support 2 x 2 x 8 Pillar
>
> Probably should come up with some name for the 2x2 stud with pin
> connector, and use that on all parts with that connector.
>
> Steve
That pin in the middle, appears to add significantly to avoid unintentional
disconnect. The tallness of the pillar with respect to the shortness of a
typical stud would cause it to be much less stable without the pin. The Jack
Stone parts don't just have tubes on the bottom, they have an arrangement within
the tube to mesh with the pin.
Ray
|
|
Message is in Reply To:
 | | Re: Name this Jack Stone part
|
| (...) Hmm.... Brick 10 x 10 with Corner Extensions Brick 10 x 10 with Corner Support Extensions Brick 12 x 12 without Sides Jack Stone BaseBrick 10 x 10 Whichever dimension (10x10 or 12x12) is used in the part, the *other* dimension should be (...) (23 years ago, 5-Feb-02, to lugnet.cad.dev)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
