To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.devOpen lugnet.cad.dev in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / Development / 6838
6837  |  6839
Subject: 
Re: Name this Jack Stone part
Newsgroups: 
lugnet.cad.dev
Date: 
Tue, 5 Feb 2002 05:55:11 GMT
Viewed: 
408 times
  
In lugnet.cad.dev, Ray Sanders writes:
This is a new part from the Jack Stone line. It has a part number on the bottom,
# 30645. The speciman I have here is black (from 4610). You may have seen it in
the set images as a floor piece for the buildings.

It is 1 brick high.

Is is nominally 10 x 10, but the cornermost studs (on all four corners) overlap
with what appears to be a 2 x 2 brick shape with vertical grooves and a thin
vertical pin centered between the four studs. If you put a normal 2 x 2 brick on
it, the  pin will fit neatly into the tube on the bottom of the 2 x 2. So,
depending on your perspective, this is either a 10 x 10 brick with corner
extensions, or a 12 x 12 brick with 1 x 8 missing on each of the four sides.

On two of the 8-wide faces, there are three technic pin holes (centered).

Peeron and brickbay have no entry for this part as of yet.

What shall we name it ?

Ray

And while we/you are thinking about this, the 2 x 2 x 8 column piece (p/n 30646)
also needs a name. It has a vertical groove on all four sides and has internal
structure on two of four sides.

Thanks, Ray



Message has 1 Reply:
  Re: Name this Jack Stone part
 
(...) Hmm.... Brick 10 x 10 with Corner Extensions Brick 10 x 10 with Corner Support Extensions Brick 12 x 12 without Sides Jack Stone BaseBrick 10 x 10 Whichever dimension (10x10 or 12x12) is used in the part, the *other* dimension should be (...) (23 years ago, 5-Feb-02, to lugnet.cad.dev)

Message is in Reply To:
  Name this Jack Stone part
 
This is a new part from the Jack Stone line. It has a part number on the bottom, # 30645. The speciman I have here is black (from 4610). You may have seen it in the set images as a floor piece for the buildings. It is 1 brick high. Is is nominally (...) (23 years ago, 5-Feb-02, to lugnet.cad.dev)

4 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR