 | | Name this Jack Stone part
|
|
This is a new part from the Jack Stone line. It has a part number on the bottom, # 30645. The speciman I have here is black (from 4610). You may have seen it in the set images as a floor piece for the buildings. It is 1 brick high. Is is nominally (...) (23 years ago, 5-Feb-02, to lugnet.cad.dev)
|
| |
| | Re: Name this Jack Stone part
|
|
(...) And while we/you are thinking about this, the 2 x 2 x 8 column piece (p/n 30646) also needs a name. It has a vertical groove on all four sides and has internal structure on two of four sides. Thanks, Ray (23 years ago, 5-Feb-02, to lugnet.cad.dev)
|
| |
| | Re: Name this Jack Stone part
|
|
(...) Hmm.... Brick 10 x 10 with Corner Extensions Brick 10 x 10 with Corner Support Extensions Brick 12 x 12 without Sides Jack Stone BaseBrick 10 x 10 Whichever dimension (10x10 or 12x12) is used in the part, the *other* dimension should be (...) (23 years ago, 5-Feb-02, to lugnet.cad.dev)
|
| |
| | Re: Name this Jack Stone part
|
|
(...) That pin in the middle, appears to add significantly to avoid unintentional disconnect. The tallness of the pillar with respect to the shortness of a typical stud would cause it to be much less stable without the pin. The Jack Stone parts (...) (23 years ago, 5-Feb-02, to lugnet.cad.dev)
|
