 | | Re: Part Numbering Crisis in LDraw
|
|
(...) You rang? :-P The pink raft (dinghy is too much typing :-) can be seen here: (URL) Now the canoe is a different matter....... Oh gawd. :-P When even *I* get the joke, it's old news Terry. -- joshua (26 years ago, 10-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: Part Numbering Crisis in LDraw
|
|
Steve Bliss wrote in message <36e52d27.5283445@lu...et.com>... (...) Not that I think this should affect the outcome of this discussion or anything, but there is at least one part that has a 7xxxx number stamped on it. The gold insectoid eye (i.e. (...) (26 years ago, 10-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: [Parts] Plate 1x1 Round with Towball
|
|
(...) Again, confusion (<g>): The question on the table is whether the BALL has a hole in it, NOT the stud... (All of mine have always had a hole through the stud). Of course, you did write "hole in the tow ball" earlier, so I'm presuming that this (...) (26 years ago, 10-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: [Parts] Plate 1x1 Round with Towball
|
|
(...) No. I am very distinctly talking about the older item. I'm not sure what the new item you are talking about, but both of the elements that I described were in my collection years before Dk Grey became available, and both have a ball and a (...) (26 years ago, 10-Mar-99, to lugnet.cad.dev)
|
| |
| | Re: Technic Axles - go rounded?
|
|
(...) I've actually run into a problem once with the axle being too long. I was trying to model a craft that I built, and I ended up fudging the virtual model by pushing the axle into the motor, because otherwise it popped through the radar dish on (...) (26 years ago, 10-Mar-99, to lugnet.cad.dev)
|
