CAD Development : 3633


CAD / Development / 3633	3632 \| 3634

Subject:	Re: Making LDraw Parts
Newsgroups:	lugnet.cad.dev, lugnet.cad.dev.org.ldraw
Date:	Fri, 14 Jan 2000 09:45:13 GMT
Viewed:	963 times

Chris and Rui: I have corrected the FAQ. Please check that I didn't add some new mistakes meanwhile. Play well, Jacob ------------------------------------------------ -- E-mail: sparre@cats.nbi.dk -- -- Web...: <URL:http://www.ldraw.org/FAQ/> -- ------------------------------------------------

Message has 2 Replies:

		Re: Making LDraw Parts
(...) I personally prefer "line defined by" instead of "line between" in that particular paragraph, but it's ok. If you changed anythink else in the FAQ, I haven't reread it to check. See ya. Rui Martins (25 years ago, 14-Jan-00, to lugnet.cad.dev, lugnet.cad.dev.org.ldraw)

		Re: Making LDraw Parts
Jacob Sparre Andersen wrote... (...) Well, I think the FAQ is still wrong: (...) Draws a line between the first two points, if the projections of the LAST TWO points onto the screen are on the same side of an imaginary line THROUGH the projections (...) (25 years ago, 14-Jan-00, to lugnet.cad.dev, lugnet.cad.dev.org.ldraw)

Message is in Reply To:

		Re: Making Ldraw Parts
(...) only (...) Yes the correction is needed. The first two point define the line, the last two are the reference points. Chris (25 years ago, 13-Jan-00, to lugnet.cad.dev, lugnet.cad.dev.org.ldraw)

17 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search