Subject:
|
Re: Voting page for 9906
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Tue, 17 Aug 1999 20:40:33 GMT
|
Viewed:
|
464 times
|
| |
|
|
Chris Dee <chris_w_dee@hotmail.com> wrote in message
news:FGMLMJ.54o@lugnet.com...
> In lugnet.cad.dev, Jeff Stembel writes:
> > I noticed something else. The Barrel 3x3x3.5 should be 4x4x3.5. Also, its
> > insertion point needs changing. It floats a couple(4?) LDUs over a brick • when
> > moved normally.
> >
> > Jeff
> Yes you're right it should be named 4x4x3.5, my mistake, and the origin is
> rather obscure. Any opinions, anyone, on where the origin should be located -
> on the small barrel the origin is at the top to aid placement of a 2x2 round
> plate as a lid. Should I do the same for this (a 4x4 dish can be used as a • lid)
> ?
Maybe just make sure that the insertion point is 8*n LDU above the bottom, so
that it can be correctly placed in regular movement mode.
-John Van
|
|
Message has 1 Reply:
 | | Re: Voting page for 9906
|
| I have re-aligned it so that the origin is level with the bottom surface, and re-submitted it to Terry. Chris (...) - (...) (25 years ago, 13-Sep-99, to lugnet.cad.dev)
|
Message is in Reply To:
| | Re: Voting page for 9906
|
| (...) Yes you're right it should be named 4x4x3.5, my mistake, and the origin is rather obscure. Any opinions, anyone, on where the origin should be located - on the small barrel the origin is at the top to aid placement of a 2x2 round plate as a (...) (25 years ago, 17-Aug-99, to lugnet.cad.dev)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
