Subject:
|
Re: Voting page for 9906
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Tue, 17 Aug 1999 20:15:55 GMT
|
Viewed:
|
1189 times
|
| |
|
|
In lugnet.cad.dev, Jeff Stembel writes:
> I noticed something else. The Barrel 3x3x3.5 should be 4x4x3.5. Also, its
> insertion point needs changing. It floats a couple(4?) LDUs over a brick when
> moved normally.
>
> Jeff
Yes you're right it should be named 4x4x3.5, my mistake, and the origin is
rather obscure. Any opinions, anyone, on where the origin should be located -
on the small barrel the origin is at the top to aid placement of a 2x2 round
plate as a lid. Should I do the same for this (a 4x4 dish can be used as a lid)
?
Chris
|
|
Message has 1 Reply:
 | | Re: Voting page for 9906
|
| Chris Dee <chris_w_dee@hotmail.com> wrote in message news:FGMLMJ.54o@lugnet.com... (...) when (...) lid) (...) Maybe just make sure that the insertion point is 8*n LDU above the bottom, so that it can be correctly placed in regular movement mode. (...) (27 years ago, 17-Aug-99, to lugnet.cad.dev)
|
Message is in Reply To:
| | Re: Voting page for 9906
|
| (...) I noticed something else. The Barrel 3x3x3.5 should be 4x4x3.5. Also, its insertion point needs changing. It floats a couple(4?) LDUs over a brick when moved normally. Jeff (27 years ago, 3-Aug-99, to lugnet.cad.dev)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
