 | | Re: Voting page 9905
|
| (...) Some notes (viewing in LEDIT): 30082 - (MINOR) Why not center this one on the ball? 6222 - (MINOR) There are some extra lines on the bottom of this piece, reaching from a single side of the 4 cardinal half-cylinders to the outside edge of the (...) (25 years ago, 1-Jun-99, to lugnet.cad.dev)
| | | | | Re: Voting page 9905
|
| (...) 4265 has a full cross-shaped axle hole. 4265b has the so-called "hourglass" axle hole, i.e. it is missing two opposing triangles. Hope this helps! Jeff (25 years ago, 1-Jun-99, to lugnet.cad.dev)
| | | | | Re: Voting page 9905
|
| (...) Hmm. Why not, indeed? (...) I'm not seeing these. Of course, it took me about 5 minutes to figure out how you were viewing this piece in LEdit, since the part-file has almost 1500 lines. Steve (25 years ago, 2-Jun-99, to lugnet.cad.dev)
| | | | | Re: Voting page 9905
|
| (...) The placement of this part was discussed here before submitting it. It is probably not at all clear how it should be centered, but this was chosen as a compromise. The current placement should make it easy to use in a piston engine, which (...) (25 years ago, 2-Jun-99, to lugnet.cad.dev)
| | | | | Re: Voting page 9905
|
| (...) :-S Oops. I can be more specific (but it's really a minor issue): I am viewing it in LEdit at 2x magnification, at the underside. Underneath, you see the center cylinder, with four sets of two half-cylinders forming a cross around it. The (...) (25 years ago, 2-Jun-99, to lugnet.cad.dev)
| | | | | Re: Voting page 9905
|
| (...) If you want to do so, be my guest. Just send it in before it is officialized. -- Terry K -- (25 years ago, 3-Jun-99, to lugnet.cad.dev)
| |
