Subject:
|
Re: Part Name Question
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Tue, 18 May 1999 20:36:59 GMT
|
Viewed:
|
789 times
|
| |
|
|
Jeff Stembel <Dragonelf1@aol.com> wrote in message
news:FBy0GA.6Lt@lugnet.com...
> In lugnet.cad.dev, Steve Bliss writes:
> > On Tue, 18 May 1999 17:32:52 GMT, "Jeff Stembel" <Dragonelf1@aol.com>
> > wrote:
> >
> > > Will the 1x1 end of it use capitalization? (i.e. STUD.DAT)
> >
> > Hadn't thought about that. Is it that important to view a stud instead of
> > a line in LEdit? Seems like this piece has a 'normal geometry', so that it
> > wouldn't make sense to defeat the line-as-stud option.
>
> Now that I think about it, it probably isn't necessary. I had a hard time
> positioning things on the end using John's mock-up, but I just realized it • was
> probably because he was using one of the 'stud' primitives. So, Nevermind. • ;)
>
You're right, that was a pain. I think I worked in LDAO modeler just for that
reason.
-John Van
|
|
Message is in Reply To:
 | | Re: Part Name Question
|
| (...) Now that I think about it, it probably isn't necessary. I had a hard time positioning things on the end using John's mock-up, but I just realized it was probably because he was using one of the 'stud' primitives. So, Nevermind. ;) Jeff (26 years ago, 18-May-99, to lugnet.cad.dev)
|
7 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
