 | | Part Name Question
|
| I'm finalizing the "Star Wars Ion Cannon" part, and neither John nor I can think of a decent name for it. Heck, what *category* should it be in? John has suggested one of the following categories: Bar Support Space And I've got the following (...) (26 years ago, 18-May-99, to lugnet.cad.dev)
| | | | | Re: Part Name Question
|
| (...) I like Bar or support. Those, IMO, are the most-likely non-space use of it. (...) Will the 1x1 end of it use capitalization? (i.e. STUD.DAT) Also, a problem that I noticed with John's mock-up is that the end cylinder was *not* the same (...) (26 years ago, 18-May-99, to lugnet.cad.dev)
| | | | | Re: Part Name Question
|
| (...) Hadn't thought about that. Is it that important to view a stud instead of a line in LEdit? Seems like this piece has a 'normal geometry', so that it wouldn't make sense to defeat the line-as-stud option. (...) Yes. Steve (26 years ago, 18-May-99, to lugnet.cad.dev)
| | | | | Re: Part Name Question
|
| (...) Now that I think about it, it probably isn't necessary. I had a hard time positioning things on the end using John's mock-up, but I just realized it was probably because he was using one of the 'stud' primitives. So, Nevermind. ;) Jeff (26 years ago, 18-May-99, to lugnet.cad.dev)
| | | | | Re: Part Name Question
|
| Jeff Stembel <Dragonelf1@aol.com> wrote in message news:FBy0GA.6Lt@lugnet.com... (...) was (...) ;) (...) You're right, that was a pain. I think I worked in LDAO modeler just for that reason. -John Van (26 years ago, 18-May-99, to lugnet.cad.dev)
| | | | | Re: Part Name Question
|
| (...) i say space (...) space gun 1 x 8 dsounds good. (26 years ago, 19-May-99, to lugnet.cad.dev)
| | | | | Re: Part Name Question
|
| jonathan wilson wrote in message ... (...) No, no more "space" required I think. A generic category like "bar" would be nicer. But I admit that there is no simple definition for "bar" category for this part like "space gun 1x8" Selçuk (26 years ago, 19-May-99, to lugnet.cad.dev)
| |
