CAD Development : 1735


CAD / Development / 1735	1734 \| 1736

Subject:	Re: Un-Official Part: Technic Connector with Axle Hole
Newsgroups:	lugnet.cad.dev
Date:	Mon, 17 May 1999 01:48:17 GMT
Viewed:	754 times

"jonathan wilson" <wilsonj@xoommail.com> writes: > good. does this mean that you will now be finishing your engine parts??? I probably should, yes. As for the 2853 Technic Crankshaft, my draft at http://www.math.uio.no/~fredrigl/technic/ldraw/ is obvoiusly misplaced -- It's not centered. So when I make a proper one, I need to update all my models: Bah. Anyway, how should the part be placed and rotated? I reckon the axle part of it should be placed like the 3704 Technic Axle #2, but which way should the offset thingey point? Any opinions? And what do I do to get a number for a specific part? I have two unofficial parts which lack numbers: "Technic Connector with Axle Hole" and "Technic Friction Peg with Towball", both at http://www.math.uio.no/~fredrigl/technic/ldraw/ Fredrik

Message has 1 Reply:

		Re: Un-Official Part: Technic Connector with Axle Hole [DAT]
(...) Well, as this piece is commonly used with the 2854, and that piece is already in the vote in its own position, I would place the 2853 in the default position easiest to use with the 2854. That would require a 180 degree flip of the 2853 and a (...) (26 years ago, 17-May-99, to lugnet.cad.dev)

Message is in Reply To:

		Re: Un-Official Part: Technic Connector with Axle Hole
good. does this mean that you will now be finishing your engine parts??? (26 years ago, 16-May-99, to lugnet.cad.dev)

5 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search