Subject:
|
Re: Part Request: 30200
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Tue, 6 Apr 1999 11:48:34 GMT
|
Viewed:
|
875 times
|
| |
|
|
In lugnet.cad.dev, Karim Nassar writes:
> > Shoot, your right. I assumed they were 4 ldu radius, but an antenna slips
> > right in and out. They must be about 4.25 or 4.5 ldu radius. Anybody want • to
> > check with a calliper? In any case, I agree it's wierd.
>
> Ok, I've got my calipers here, and I'm reading .1325 inches in diameter. I
> plug that figure into my trusty HP28S and get a conversion to 3.3655mm, and
> half of that is 1.68275mm radius.
>
> I'll leave the conversion to LDUs to you :)
>
> --Karim
Without getting into the metric versus imperial debate again... but using
my assumption that the are 64 LDUs to the inch, 0.1325 inches is close enough
to 8.5 LDU.
Chris
|
|
Message is in Reply To:
 | | Re: Part Request: 30200
|
| (...) Ok, I've got my calipers here, and I'm reading .1325 inches in diameter. I plug that figure into my trusty HP28S and get a conversion to 3.3655mm, and half of that is 1.68275mm radius. I'll leave the conversion to LDUs to you :) --Karim (26 years ago, 5-Apr-99, to lugnet.cad.dev)
|
8 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
