CAD Development : 1006

CAD / Development / 1006

1005 | 1007

Subject:	Re: baseplate 32 x 32 road curve with road pattern-9 studs
Newsgroups:	lugnet.cad.dev
Date:	Tue, 6 Apr 1999 01:59:12 GMT
Viewed:	2934 times

> Did you also notice that the curved lines look a bit choppy yes... that is becahse of the number of quads in the output of steves torus generator. > and that the green and white decorations seem to float below the main surface • rather than > above or coincident with it? (I'm viewing it with LDLITE 1.6.) i will look at that. regarding the baseplate problem. ldraw does not yet have the 8-stud versions. i will submit it for voting as posted to cad.dat and then see what terry says. i think that someone needs to start ldrawing the 8-stud varients of the plates then...

Message has 1 Reply:

		Re: baseplate 32 x 32 road curve with road pattern-9 studs
(...) I'm thinkin' maybe the torus generator was designed with smaller parts in mind, where the coarse angular granularity is far less noticeable than on a baseplate. What other mathematical methods of generating coordinates on a circle do you know (...) (28 years ago, 6-Apr-99, to lugnet.cad.dev)

Message is in Reply To:

		Re: baseplate 32 x 32 road curve with road pattern-9 studs
(...) Say, before you submit it for voting, I have a couple more questions: Did you also notice that the curved lines look a bit choppy and that the green and white decorations seem to float below the main surface rather than above or coincident (...) (28 years ago, 5-Apr-99, to lugnet.cad.dev)

32 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact