 | | Re: Proposal: New Parts Category for round parts
|
|
(...) OK. I generally use 'rod' as a straight synonym for 'bar'. If some other people like 'Technic Rod', then let's go with that. (...) In that case, can we move the 'Brick with pin(s)' parts to Technic Brick? (...) Oooo, cool. :) So it *is* a (...) (23 years ago, 8-Jan-02, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: Proposal: New Parts Category for round parts
|
|
(...) Sorry, I was being too terse. I meant 'technic brick', not just plain 'brick'. Likewise, 'technic beam', not just 'beam'. (...) That's a possibility. Organization-wise, I'd like to split Technic up into two or more categories, just because (...) (23 years ago, 8-Jan-02, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: Proposal: New Parts Category for round parts
|
|
(...) Yes, but it passes the "Is it?" test. This is the test we'd have to use to account for the Technic and Slope categories found in the LDraw parts library. Technic and Slope are both adjectives, as used in part names. We've got parts like (...) (23 years ago, 8-Jan-02, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: Proposal: New Parts Category for round parts
|
|
(...) I think I like the upper version, but I'm not sure. I suppose we can't have both? :-) BTW, we may benefit from using " 1 x 3" rather "3L". This may make it easier to incorporate the L shaped beams. (...) I think there exists a 3 hole full (...) (23 years ago, 8-Jan-02, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: Proposal: New Parts Category for round parts
|
|
(...) I tend to view bar-like elements with a connector socket in each end as a "rod". Hence, "tie-rod" sounds too complicated to me. But I can't claim too much knowledge about English mechanics. I think your suggestion is good! (...) But that's not (...) (23 years ago, 8-Jan-02, to lugnet.cad.dev.org.ldraw)
|
