| | Re: Suggestion for new meta command & help request
|
|
(...) I don't understand this. What if the user wants to rotate by something which isn't a multiple of 90°? Say, 30°? If the rotation point is off by one (or even a half) stud, it isn't going to work to offset the part afterwards. Unless you offset (...) (24 years ago, 24-Apr-00, to lugnet.cad.dev)
|
|
| | Re: Voting Open for LCAD Parts Update 2000-01
|
|
(...) Sounds good to me! (...) I think they should be combined. We don't have that many propellers/rotors anyway. Besides, it is probably better to put them in the same category, as the user will spend less time searching for individual parts. (...) (24 years ago, 24-Apr-00, to lugnet.cad.dev)
|
|
| | Re: Suggestion for new meta command & help request
|
|
(...) I believe the problem is not the rotation point itself if the center for rotations is set to a stud or between two studs every thing would work fine, since the default step width of MLCad is halve a stud. So after rotating you can place it (...) (24 years ago, 24-Apr-00, to lugnet.cad.dev)
|
|
| | Re: Help for povray needed!
|
|
(...) about this trick. Michael (24 years ago, 24-Apr-00, to lugnet.cad.dev)
|
|
| | Re: Voting Open for LCAD Parts Update 2000-01
|
|
(...) How about the following name-changes: 6041.DAT Propeller 3 Blade 1.5 Diameter 4617.DAT Propeller 3 Blade 5.5 Diameter The only other information morphological information would be connection-type, but I don't see a strong need for that. Here's (...) (24 years ago, 24-Apr-00, to lugnet.cad.dev)
|