|
| | Re: 71184 Bar 4.5L Straight is too short
|
| (...) I don't have the fix, but I did locate it on lugnet.cad.dat.parts. Normally, I'd require you to e-mail me the fix before I'd put it in an official release, but since you're a good modeler, I'll let it go this once. Just don't tell anyone. ;) (...) (25 years ago, 7-Apr-00, to lugnet.cad.dev)
| | | | Re: Some Words To BFC
|
| (...) OK, here's a counter-proposal: don't require all parts/primitives to be BFC'able, and allow both BFC-ready and BFC-not-ready files in the same rendering. This reintroduces the concept of having a single meta-statement at the start of each (...) (25 years ago, 7-Apr-00, to lugnet.cad.dev)
| | | | Re: Performance Improvement [DAT]
|
| (...) As I said before, in this case it's more correct to use 3-4disc primitive, to avoid the T type juntions. (...) Yes, cracks may appear ! Same problem like in a T type junction But has someone said, nothing like real/concrete testing, so here (...) (25 years ago, 7-Apr-00, to lugnet.cad.dev)
| | | | Re: Performance Improvement
|
| Steve: (...) I can't see how Rui's suggested change gives any problems at all and I don't mind a few percent speed increase. (...) And? Does the "diameter line" not cross the radius? If there is a significant risk of a misalignment, then we (...) (25 years ago, 7-Apr-00, to lugnet.cad.dev)
| | | | Re: Some Words To BFC
|
| On Fri, 7 Apr 2000, Leonardo Zide wrote: [...SNIP...] (...) Actually I think you missunderstood something (or maybe I did), but the 0 INVERSE meta command is to be used ONLY with file references, that is: 0 INVERSE 1 16 x y z a b c d e f g h i (...) (25 years ago, 7-Apr-00, to lugnet.cad.dev)
| |