| | Re: parts i plan to do
|
|
regarding boat mast primatives they are later going to be omdified to add the notches in the top (26 years ago, 28-Feb-99, to lugnet.cad.dev)
|
|
| | Re: parts i plan to do
|
|
(...) how (...) Almost any part which has convex curved surfaces will need type 5 lines. Obviously if you can make use of the circular primitives, then they already include the type 5 lines. For example take a look at the town/space helmet (2446) of (...) (26 years ago, 28-Feb-99, to lugnet.cad.dev)
|
|
| | Re: parts i plan to do
|
|
(...) I was referring to that long list of pieces. Not any one particular piece. But if the piece has some complex curves in it, there is a good chance it will need type 5 lines to do it properly. For an example off the top of my head, see part (...) (26 years ago, 28-Feb-99, to lugnet.cad.dev)
|
|
| | Re: Part Numbering Crisis in LDraw
|
|
Steve Bliss wrote in message <36d6fef8.20191570@l...et.com>... (...) doesn't (...) Six Red ones come in the Extreme Team: Drag Race Rally, 6568. And I know I have some from other sets. They're around.... How badly do you want them? A local Kmart (...) (26 years ago, 28-Feb-99, to lugnet.cad.dev)
|
|
| | Re: part: boat mast base 4 x 4
|
|
i have just posted a fixed version of this piece to lugnet.cad.dat. let mw know if it is now fixed. the notches are still missing because i do not know how to adjuct the cylinders etc after i have inlined them. (26 years ago, 28-Feb-99, to lugnet.cad.dev)
|
|
| | Re: parts i plan to do
|
|
(...) complex (...) which parts need type 5 lines? i have done the boat mast base. get it from lugnet.cad.dat i am working on the notches at the top. (26 years ago, 28-Feb-99, to lugnet.cad.dev)
|
|
| | Re: parts i plan to do
|
|
(...) Good advice, Chris. I would like to also point out that many of the parts in that list have complex shapes that would require type 5 optional lines to have them look good. So Jonathan, you really need to have a good understanding of type 5 (...) (26 years ago, 28-Feb-99, to lugnet.cad.dev)
|
|
| | Re: part: panel 1 x 2 x 1 with black grille pattern
|
|
(...) Your method also makes the pattern show up in wire-frame mode. Ideally, all the current parts should be changed to use the same method! Anyone want to take the challenge? --Bram Bram Lambrecht / o o \ BramL@juno.com (...) (26 years ago, 28-Feb-99, to lugnet.cad.dev)
|
|
| | Re: part: panel 1 x 2 x 1 with black grille pattern
|
|
i accually pulled the pattern straight of the 1 x 2 brick with black grille pattern because the patterened surfaces are the same size (26 years ago, 27-Feb-99, to lugnet.cad.dev)
|
|
| | Re: part: boat mast base 4 x 4
|
|
thanks for the help. i will get onto the fixes asap (26 years ago, 27-Feb-99, to lugnet.cad.dev)
|