Subject:
|
Re: part: panel 1 x 2 x 1 with black grille pattern
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Sun, 28 Feb 1999 00:39:52 GMT
|
Viewed:
|
1233 times
|
| |
|
|
John Van wrote:
> Here's another tip I use when making patterns for parts:
> ...
Your method also makes the pattern show up in wire-frame mode. Ideally,
all the current parts should be changed to use the same method! Anyone
want to take the challenge?
--Bram
Bram Lambrecht / o o \ BramL@juno.com
-------------------oooo-----(_)-----oooo-------------------
WWW: http://www.chuh.org/Students/Bram-Lambrecht/
-----------------------------------------------------------
|
|
Message is in Reply To:
 | | Re: part: panel 1 x 2 x 1 with black grille pattern
|
| Good work on this one, but I might suggest using quads instead of rect.dat for the black lines (does James' pattern use these?). Black rect.dat's have dark grey edge lines around them, and I don't thik there is any dark grey on this pattern. Here's (...) (26 years ago, 27-Feb-99, to lugnet.cad.dev)
|
4 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
