 | | Re: Part Numbering Crisis in LDraw
|
|
Sproaticus wrote in message ... (...) My vote would be to use the part number that people can see with out takeing apart the boat, i.e. the 30086 number. The 30087 number is only of value if you take the boat apart. Somthing I feel very few people (...) (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
(...) need (...) You should measure with a ruler or with lego parts (or for detailed parts people have resorted to calipers). With a plate and a brick, you can make pretty accurate measurements based on wall thickness (4 ldu), plate thickness (8 (...) (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: Part Numbering Crisis in LDraw
|
|
Terry K wrote in message <36d5fd53.5480877@lu...et.com>... (...) seemingly (...) number (...) both (...) I thought you had to break the two halves apart to get at the 30087 number. Do you have to break it apart? If so can you use them afterward? If (...) (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
jonathan wilson wrote in message ... (...) go (...) need (...) Its precise enough for me. Since we already know that LDraw itself is not accurate, but it is precise. Roy (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
jonathan wilson wrote in message ... (...) done (...) You know, I've never looked at the bottom since you usually can't do anything with the bottom of a baseplate. Matter of fact I don't think I've ever looked at any of the real ones I have other (...) (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
