 | | Re: DAT voting page up
|
|
(...) It's not *that* hard to go from the line drawings to raised forms. Especially since each numeral only needs to be done once. That LEGO logo and copyright notice, now. Those are a whole different level of challenge. Steve (26 years ago, 25-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: Java LDraw/LDLite
|
|
(...) Another benefit of a Java version is that it's *much* easier to write networkable apps with Java than with C / C++. Parts updates can be automagically downloaded and installed from a "parts server"; alternatively, individual parts could be (...) (26 years ago, 25-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
Steve Bliss wrote in message <36d579c3.1627208@lu...et.com>... (...) The point here would be that line drawings would not be accurate since the part numbers I've seen are raised and moulded as are the lot numbers and some even have copyrights (...) (26 years ago, 25-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: My proposal for new element orientation
|
|
(...) This would contradict some existing standards. For example, all 2xN bricks and plates currently have the N oriented on the X axis. Under the stud-logo orientation, they'd have to all be rotated 90-degrees. Also, the stud-logo should be (...) (26 years ago, 25-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
LDraw and LDLite have the same problem, but to a lesser extent. That's why it's so important to remove the blank-face on decorated elements. Steve (...) (26 years ago, 25-Feb-99, to lugnet.cad.dev)
|
