 | | Re: fixes??
|
|
(...) No, I don't get the full circle at any resolution, there is always the missing section from about 7:00 to 11:00. I'm viewing these in ldlite, though I believe I've seen this before in ldraw and ledit.. I'll take another look though just to be (...) (25 years ago, 30-May-99, to lugnet.cad.dev)
|
| |
| | Re: what happened to the train wheel rubber ring
|
|
(...) well jon i WILL be making it. LOL im buisy making 30407 now (25 years ago, 30-May-99, to lugnet.cad.dev)
|
| |
| | Re: fixes??
|
|
(...) I'm not sure this is a problem with the primitives themselves - more an issue with the renderer? When you view from above at high magnification, do you get the complete circle? If so, this should prove that all the lines are defined in the (...) (25 years ago, 30-May-99, to lugnet.cad.dev)
|
| |
| | Re: Voting page 9905
|
|
(...) Yes, there are two variants of this piece, one with a rectangular slot, and one with a circular. To me, the circular one seems to be more frequent, but it may just be here in Europe. I dunno. Fredrik (25 years ago, 30-May-99, to lugnet.cad.dev)
|
| |
| | Re: stud.dat vs STUD.DAT
|
|
(...) Maybe. The stud-as-line drawing, and the location of the stud, are pretty obvious already. So it is not critically needed. -- Terry K -- (25 years ago, 30-May-99, to lugnet.cad.dev)
|
| |
| | stud.dat vs STUD.DAT
|
|
i think that the stud.dat reference in the technic pin 1/2 should be capatilised (25 years ago, 30-May-99, to lugnet.cad.dev)
|
| |
| | what happened to the train wheel rubber ring
|
|
i remember seeing something about the train wheel rubber ring being made... who made it and where can i get it? (25 years ago, 30-May-99, to lugnet.cad.dev)
|
| |
| | part renaming ideas
|
|
here are some part re-naming ideas castle dragon flame to minifig fire castle goblet to minifig goblet castle lance to minifig lance castle magic wand to minifig magic wand castle pike to minifig pike castle shield to minifig shield castle sword to (...) (25 years ago, 30-May-99, to lugnet.cad.dev)
|
| |
| | Re: part question: 30358
|
|
(...) Yes, it is necessary. (...) First off, I would not use the primitives for this intersection. Once the highest Y value of the intersecting curve is known, I would scale the stud2a.dat primitive to reach that point. To find the points for the (...) (25 years ago, 30-May-99, to lugnet.cad.dev)
|
| |
| | fixes??
|
|
Is it possible for someone to fix the stud.dat primitives so there aren't holes in the tops of the studs in the detail lines? Or is this only the way every brick and plate draws on my system? it seems there is always a hole in the detail line upper (...) (25 years ago, 29-May-99, to lugnet.cad.dev)
|
