 | | Re: Voting Comments
|
|
(...) That's a really great idea! It's obvious you're pretty experienced with LDraw. I'll do the changes when I get home. Fredrik (25 years ago, 19-May-99, to lugnet.cad.dev)
|
| |
| | Re: Voting Comments
|
|
(...) You are indeed correct, yes. Thanks a lot. I took the time to "brush up" the surface around the axle holes as well. I believe the current solution is a better one; I no longer use partially overlapping 2-4rings to cover the surface. The part (...) (25 years ago, 19-May-99, to lugnet.cad.dev)
|
| |
| | Re: Voting Page [DAT]
|
|
I've noticed an error in part #30250, that was named "Brick 2 x 4 x 3 Notched with Side 5 x 4 Plate" during the vote. Four box5.dat primitives have been used to form "friction rims" at the under/inside of the part, but they are not properly rotated. (...) (25 years ago, 19-May-99, to lugnet.cad.dev)
|
| |
| | Re: Part Name Question
|
|
jonathan wilson wrote in message ... (...) No, no more "space" required I think. A generic category like "bar" would be nicer. But I admit that there is no simple definition for "bar" category for this part like "space gun 1x8" Selçuk (25 years ago, 19-May-99, to lugnet.cad.dev)
|
| |
| | Re: new part description changes?
|
|
Terry K wrote in message <37422782.12164362@l...et.com>... (...) Any (...) Looks nice to me, too. (...) Corners", (...) I strongly agree. By the way, I don't think the part that Steve pointed out should be considered as "w/o corners" variety. It is (...) (25 years ago, 19-May-99, to lugnet.cad.dev)
|
| |
| | Re: Piece needed to finish MOC Naboo Fighter
|
|
(...) Yes, someone *please* do this. It has been on my wish list for ages. One of those "I can't believe it hasn't been done" pieces. (1) -- Terry K -- 1. FYI, the piece does exist in Lutz's L2P. (25 years ago, 19-May-99, to lugnet.cad.dev)
|
| |
| | Re: Part 2429
|
|
(...) No, you didn't miss something. I missed something. I thought I had carefully checked all number changes for conflicts with existing parts, but obviously, I didn't catch that one. 2429 was the Hinge Plate, released in the original LDraw (...) (25 years ago, 19-May-99, to lugnet.cad.dev)
|
| |
| | Re: Part Name Question
|
|
(...) i say space (...) space gun 1 x 8 dsounds good. (25 years ago, 19-May-99, to lugnet.cad.dev)
|
| |
| | Re: [makelist] mklist v1.2
|
|
(...) Consider it done. -- Terry K -- (25 years ago, 19-May-99, to lugnet.cad.dev)
|
| |
| | Re: new part description changes?
|
|
(...) I favor this one as well. (...) I agree. And as Steve pointed out, there is precedence for "without Corners", whereas there is none for "Tapered". (...) Cow-like, I will follow this herd and agree. (...) Beat me to it! I was just going to say (...) (25 years ago, 19-May-99, to lugnet.cad.dev)
|
