| | Re: LPub mask generation
|
|
(...) I'm not entirely sure, but I'm pretty sure you can create a 32bpp BMP file. Normally, 8 bits in each pixel would then be ignored. However, I don't see any reason the data wouldn't be there for you to interpret yourself. --Travis Cobbs (20 years ago, 15-Sep-04, to lugnet.cad.dev)
|
|
| | LPub mask generation
|
|
I added mask generation for assembly images into LPub. It now can generate a specific mask for each assembly image. I plan on using this for the layout process, where you provide a backdrop image for a page, and LPub uses a mask to superimpose the (...) (20 years ago, 15-Sep-04, to lugnet.cad.dev)
|
|
| | Re: l3p -check without using l3p
|
|
Thanks guys, I believed there had to be some kind of easy fix to the problem (too stupid). Now I feel a lot more comfortable certifying parts! -NB (20 years ago, 12-Sep-04, to lugnet.cad.dev, FTX)
|
|
| | Re: l3p -check without using l3p
|
|
(...) Actually LDDP has a built in, full l3p check. You have to turn on the co-planarity checks under Tools->Options->Configuration Values -Orion (20 years ago, 12-Sep-04, to lugnet.cad.dev, FTX)
|
|
| | Re: l3p -check without using l3p
|
|
(...) LDAO can be used to run l3p -check without even seeing a command prompt ;) ROSCO (20 years ago, 11-Sep-04, to lugnet.cad.dev, FTX)
|
|
| | l3p -check without using l3p
|
|
Just a quick question: Is there any programs that can give you a full l3p-check other than l3p? (I not old enough to have done anything but starting games from prompt ;-) ) It seems like LDDP is pretty close to do that but although its able to find (...) (20 years ago, 11-Sep-04, to lugnet.cad.dev, FTX)
|
|
| | Re: Postscript output
|
|
(...) Has anyone gone anywhere with this? -Tim (20 years ago, 11-Sep-04, to lugnet.cad.dev)
|
|
| | Re: Bow-tie quads in BFC-certified parts
|
|
(...) I've seen them in one official part, and one part on the tracker. But since I haven't really been looking for them, I'm guessing they exists in other parts. The main culprit appears to be pre-existing parts that were later BFC-certified. (Both (...) (20 years ago, 10-Sep-04, to lugnet.cad.dev.org.ldraw)
|
|
| | Re: Bow-tie quads in BFC-certified parts
|
|
(...) How often do you find bow-tied parts in BFC CERTIFY'd parts? I meant that's a real error that shouldn't be allowed by the parts tracker isn't it? Is there a rule that can be added to the checks done on the files that are submitted that will (...) (20 years ago, 10-Sep-04, to lugnet.cad.dev.org.ldraw)
|
|
| | Re: Parts with lengths
|
|
In lugnet.cad.dev, Kevin L. Clague wrote: [snip] nod, I agree with everything you wrote. (...) Long term (*very* long term), there's nothing to say the language can't be extended to allow a different linetype for parts-with-lengths. Steve (20 years ago, 10-Sep-04, to lugnet.cad.dev)
|