 | | Need partnumbers and some partnames
|
|
Now the parts update 2003-03 is released, I started to make some parts I have already created ready for upload to the parts tracker. I need partnumbers for the following parts. I also want to know if the partnames are correct. * Technic Brick 1 x 2 (...) (21 years ago, 29-Dec-03, to lugnet.cad.dev)
|
| |
| | Re: BFC And Mirroring (LDS)
|
|
(...) Thanks Steve. :) (21 years ago, 29-Dec-03, to lugnet.cad.dev)
|
| |
| | Re: primer/tutorial on BFC?
|
|
(...) OK - it's not a technique I use, but in an email conversation recently somebody convinced me that inverting the matrix would switch the winding. Now that I test it again I found I was mistaken. Chris (21 years ago, 28-Dec-03, to lugnet.cad.dev)
|
| |
| | Re: BFC And Mirroring (LDS)
|
|
In lugnet.cad.dev, Tore Eriksson wrote: [snip] (...) Yes. Steve (21 years ago, 28-Dec-03, to lugnet.cad.dev)
|
| |
| | Re: primer/tutorial on BFC?
|
|
In lugnet.cad.dev, Chris Dee wrote: [snip] Thanks for writing this up, Chris! Your explanation was very good in all respects except for one small point: (...) Actually, negating the transformation matrix should not invert any object; and even if it (...) (21 years ago, 28-Dec-03, to lugnet.cad.dev)
|
