Subject:
|
Re: Working on 6032.dat Brick 2 x 3 x 1 & 2/3 Octagonal offset
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Fri, 8 Oct 2004 14:42:07 GMT
|
Viewed:
|
4867 times
|
| |
|
|
In lugnet.cad.dat.parts, Niels Bugge wrote:
| |
I wasn’t only talking about abandoned parts, but all the ones people are
working on that’ll take a long time to finish. (since the other ones probably
gets finished before somebody else starts on them).
But now you’re forgiven (for the sins you’ve confessed), and I would really
like to see what you have of that octagonal part: I’ve made most of it with a
high degree of primitive and subpart substitution, but has put it away for
the moment because the internal details is so difficult:
I’m fighting the bottom edges of
the internal cylinders (upper) and I’m not looking forward to the two round
holes going up from the bottom through the middle section.
Isn’t it possible to modify the PT code a bit to make a “Pre PT list” where
you could “add a number” (of the part you’re working on) as well as stuffing
in abandoned parts that other can have? The only trouble would be to
integrate them so the pre-list gets cleared when the parts is added to the PT
to avoid cluttering, but perhaps it could be made a lot simpler by just
allowing anybody delete the garbage.
That would be a really nice tool for authors.
-NB
|
This is in my “delvolopment” queue for LDraw.org features. Unless Steve adds
this to the PT, I think I can whip up a website module.
-Orion
|
|
Message is in Reply To:
8 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
