Subject:
|
Re: Working on 6032.dat Brick 2 x 3 x 1 & 2/3 Octagonal offset
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Wed, 6 Oct 2004 18:43:41 GMT
|
Viewed:
|
4568 times
|
| |
|
|
I wasn’t only talking about abandoned parts, but all the ones people are working
on that’ll take a long time to finish. (since the other ones probably gets
finished before somebody else starts on them).
But now you’re forgiven (for the sins you’ve confessed), and I would really like
to see what you have of that octagonal part: I’ve made most of it with a high
degree of primitive and subpart substitution, but has put it away for the moment
because the internal details is so difficult:
I’m fighting the bottom edges of
the internal cylinders (upper) and I’m not looking forward to the two round
holes going up from the bottom through the middle section.
Isn’t it possible to modify the PT code a bit to make a “Pre PT list” where you
could “add a number” (of the part you’re working on) as well as stuffing in
abandoned parts that other can have? The only trouble would be to integrate them
so the pre-list gets cleared when the parts is added to the PT to avoid
cluttering, but perhaps it could be made a lot simpler by just allowing anybody
delete the garbage.
That would be a really nice tool for authors.
-NB
|
|
Message has 2 Replies:
Message is in Reply To:
8 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
