Subject:
|
Re: Naming of parts
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Tue, 3 Feb 2004 22:12:04 GMT
|
Viewed:
|
8577 times
|
| |
|
|
On Tue, 3 Feb 2004, Orion Pobursky wrote:
> In general, a wedge is a 'clipped' brick and a wing is a 'clipped' plate. I
> don't see any exception to this rule in the official library but if an exception
> exists on the PT then those part should be commented upon.
The following official parts do not follow this rule:
4859
32059
2401
2450
2419
30503
6106
--
TWS Garrison
http://www.morfydd.net/twsg/
Remove capital letters in address for direct reply.
|
|
Message has 1 Reply:
 | | Re: Naming of parts
|
| (...) This one should be Wing 3 x 4 (...) These ones are plates with one corner clipped, I think the 'Without Corner' label is better than Wing. I'd like to add these ones to the list: 2621 2625 I had renamed 2625 while it was on the PT for BFC (...) (23 years ago, 4-Feb-04, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | Re: Naming of parts
|
| (...) In general, a wedge is a 'clipped' brick and a wing is a 'clipped' plate. I don't see any exception to this rule in the official library but if an exception exists on the PT then those part should be commented upon. -Orion (23 years ago, 3-Feb-04, to lugnet.cad.dat.parts)
|
21 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
