Subject:
|
Re: Parts 3480 and 3481
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Thu, 11 Dec 2003 21:13:54 GMT
|
Viewed:
|
1816 times
|
| |
|
|
That is a possibility too :-)
Anyway, it should be fixed...
Jaco
"Don Heyse" <dheyse@hotmail.spam.go.away.com> schreef in bericht
news:Hpr05B.53z@lugnet.com...
> In lugnet.cad.dat.parts, Jaco van der Molen wrote:
> > Creating a model with these 2 parts:
> > - 3480.DAT Rotor 2 Blade Helicopter Tail
> > - 3481.DAT Plate 2 x 2 with Helicopter Tail Rotor Holder
> > I discoverd that:
> > - either the inner diameter of 3480 is too small
> > - or the diameter of the Tail Rotor Holder (peg) is too wide
> >
> > (see http://www.brickshelf.com/gallery/sjaacko/Temp/3480-3481.gif)
>
> Actually it looks like the peg isn't long enough, or the cylinder
> on the blade part is too tall. The diameters look fine.
>
> > Other points on part 3480
> > - The default rotation point is not at all handy
> > - IMHO its category should be Propellor and not Rotor
> >
> > This should be ajusted.
> >
> > Jaco
|
|
Message has 1 Reply:
 | | Re: Parts 3480 and 3481
|
| I contacted the original author of these parts and he promised he'd look into it. Jaco "Jaco van der Molen" <jmolen@zonnet.nl> schreef in bericht news:Hpr1n4.Cw8@lugnet.com... (...) (21 years ago, 15-Dec-03, to lugnet.cad.dat.parts)
|
Message is in Reply To:
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
