Subject:
|
Re: Parts 3480 and 3481
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Thu, 11 Dec 2003 20:41:35 GMT
|
Viewed:
|
1809 times
|
| |
|
|
In lugnet.cad.dat.parts, Jaco van der Molen wrote:
> Creating a model with these 2 parts:
> - 3480.DAT Rotor 2 Blade Helicopter Tail
> - 3481.DAT Plate 2 x 2 with Helicopter Tail Rotor Holder
> I discoverd that:
> - either the inner diameter of 3480 is too small
> - or the diameter of the Tail Rotor Holder (peg) is too wide
>
> (see http://www.brickshelf.com/gallery/sjaacko/Temp/3480-3481.gif)
Actually it looks like the peg isn't long enough, or the cylinder
on the blade part is too tall. The diameters look fine.
> Other points on part 3480
> - The default rotation point is not at all handy
> - IMHO its category should be Propellor and not Rotor
>
> This should be ajusted.
>
> Jaco
|
|
Message has 1 Reply:
 | | Re: Parts 3480 and 3481
|
| That is a possibility too :-) Anyway, it should be fixed... Jaco "Don Heyse" <dheyse@hotmail.spam....away.com> schreef in bericht news:Hpr05B.53z@lugnet.com... (...) (21 years ago, 11-Dec-03, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | Parts 3480 and 3481
|
| Creating a model with these 2 parts: - 3480.DAT Rotor 2 Blade Helicopter Tail - 3481.DAT Plate 2 x 2 with Helicopter Tail Rotor Holder I discoverd that: - either the inner diameter of 3480 is too small - or the diameter of the Tail Rotor Holder (...) (21 years ago, 11-Dec-03, to lugnet.cad.dat.parts)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
