Subject:
|
Re: Car Wash Brush Subpart
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Sat, 18 Oct 2003 09:14:29 GMT
|
Viewed:
|
2384 times
|
| |
|
|
Bernd Broich wrote:
> Chris Dee wrote:
> > In lugnet.cad.dat.parts, Bernd Broich wrote:
> > > I've a question about the Car Wash Brush Subpart I created.
> > > http://www.ldraw.org/cgi-bin/ptdetail.cgi?f=parts/s/2473s01.dat
> > > Steve Bliss gave me a hold vote on this but I don't realy
> > > understand his arguments:
> > >
> > > "I reviewed too soon. These bristles are not radiating straight
> > > out from the center. They are turned slightly in a counter-clock-
> > > wise direction."
> > >
> > > At my real parts the stubs are coming out of the cylinder
> > > like I made the part. Does somebody else could help us here?
> >
> > I think Steve is suggesting that if you extend the centre lines of
> > each bristle, they should pass though the x=0, z=0 line. If you look
> > at this subpart from above, the bristles do not seem to radiate from
> > the part origin - the seem skewed.
>
> OK, thanks for this. You're right, I missed that.
I've fixed and submitted the part.
CU Bernd
|
|
Message is in Reply To:
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
