Subject:
|
Car Wash Brush Subpart
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Fri, 17 Oct 2003 12:50:34 GMT
|
Viewed:
|
2099 times
|
| |
|
|
Hi all,
I've a question about the Car Wash Brush Subpart I created.
http://www.ldraw.org/cgi-bin/ptdetail.cgi?f=parts/s/2473s01.dat
Steve Bliss gave me a hold vote on this but I don't realy
understand his arguments:
"I reviewed too soon. These bristles are not radiating straight
out from the center. They are turned slightly in a counter-clock-
wise direction."
At my real parts the stubs are coming out of the cylinder
like I made the part. Does somebody else could help us here?
CU Bernd
|
|
Message has 1 Reply:
 | | Re: Car Wash Brush Subpart
|
| (...) I think Steve is suggesting that if you extend the centre lines of each bristle, they should pass though the x=0, z=0 line. If you look at this subpart from above, the bristles do not seem to radiate from the part origin - the seem skewed. (...) (21 years ago, 17-Oct-03, to lugnet.cad.dat.parts)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
