Subject:
|
Re: Car Wash Brush Subpart
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Fri, 17 Oct 2003 16:26:47 GMT
|
Viewed:
|
2042 times
|
| |
|
|
In lugnet.cad.dat.parts, Bernd Broich wrote:
> Hi all,
>
> I've a question about the Car Wash Brush Subpart I created.
> http://www.ldraw.org/cgi-bin/ptdetail.cgi?f=parts/s/2473s01.dat
> Steve Bliss gave me a hold vote on this but I don't realy
> understand his arguments:
>
> "I reviewed too soon. These bristles are not radiating straight
> out from the center. They are turned slightly in a counter-clock-
> wise direction."
>
> At my real parts the stubs are coming out of the cylinder
> like I made the part. Does somebody else could help us here?
>
> CU Bernd
I think Steve is suggesting that if you extend the centre lines of each bristle,
they should pass though the x=0, z=0 line. If you look at this subpart from
above, the bristles do not seem to radiate from the part origin - the seem
skewed.
Chris
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Car Wash Brush Subpart
|
| Hi all, I've a question about the Car Wash Brush Subpart I created. (URL) Bliss gave me a hold vote on this but I don't realy understand his arguments: "I reviewed too soon. These bristles are not radiating straight out from the center. They are (...) (21 years ago, 17-Oct-03, to lugnet.cad.dat.parts)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
