 | | Re: Car Wash Brush Subpart
|
|
(...) I think Steve is suggesting that if you extend the centre lines of each bristle, they should pass though the x=0, z=0 line. If you look at this subpart from above, the bristles do not seem to radiate from the part origin - the seem skewed. (...) (23 years ago, 17-Oct-03, to lugnet.cad.dat.parts)
|
| |
| | Car Wash Brush Subpart
|
|
Hi all, I've a question about the Car Wash Brush Subpart I created. (URL) Bliss gave me a hold vote on this but I don't realy understand his arguments: "I reviewed too soon. These bristles are not radiating straight out from the center. They are (...) (23 years ago, 17-Oct-03, to lugnet.cad.dat.parts)
|
| |
| | Re: New Part: 2706.dat - Technic Action Figure Shoe
|
|
(...) Thanks, Mark. Yes, I know that there have been a lot of new box primitives lately, and someday I will try to learn to use them... :) But so far, it takes much less time to draw all lines by hand then to try to find the optimal primitive. /Tore (23 years ago, 15-Oct-03, to lugnet.cad.dat.parts)
|
| |
| | Re: New Part: 2706.dat - Technic Action Figure Shoe
|
|
(...) Done. Although the file size reduction was trivial (255 bytes) -Orion (23 years ago, 15-Oct-03, to lugnet.cad.dat.parts)
|
| |
| | Re: New Part: 2706.dat - Technic Action Figure Shoe
|
|
(...) I would suggest using the box3u8p primitve on the outside and inside of the shoe to save some space. (23 years ago, 15-Oct-03, to lugnet.cad.dat.parts)
|
