Subject:
|
Re: x342: ~Technic Flex-System End
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Sun, 28 Jul 2002 01:25:25 GMT
|
Viewed:
|
1133 times
|
| |
|
|
In lugnet.cad.dat.parts, Fredrik Glöckner writes:
> "Ross Crawford" <rcrawford@csi.com> writes:
> > Can do! Only reason its different is because Miguel's connector(s)
> > are oriented that way & I was too lazy to change it! But it's easy to
> > re-orient that too, so I've done that, the updated files are at
> > http://www.ozbricks.com/bre/etc/flex1.zip
>
>
> Sounds good, I'll check them out.
OK. Updated BFC certified versions now available at
http://www.ozbricks.com/bre/etc/flex1.zip
ROSCO
|
|
Message has 1 Reply:
 | | Re: x342: ~Technic Flex-System End [DAT]
|
| (...) No documentation has been added yet, but it works the usual way. Here's an example. Try these two end parts: 0 1 8 50 0 0 0 0 -1 1 0 0 0 -1 0 x342.DAT 1 8 0 0 50 0 -1 0 -1 0 0 0 0 -1 x342.DAT 0 Put the cursor on either of the part lines, and (...) (22 years ago, 31-Jul-02, to lugnet.cad.dat.parts)
|
Message is in Reply To:
6 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
